EMX5016CF 16-input, 500W per Channel Powered Mixer Discontinued
| Maximum Output Power @ 0.5 % THD at 1 kHz |
500 W/4 Ω 350 W/8 Ω (UA) 320 W/8 Ω (H) |
|---|---|
| Frequency Response | -3, 0, 1 dB 20Hz-20kHz, ref to the 1kHz output level, GAIN=MIN, PAD=OFF |
| Total Harmonic Distortion | Less than 0.3 % (THD+N) +14dBu output into 600 Ω @ 20 Hz-20 kHz |
| Hum & Noise | Equivalent Input Noise, -128 dBu, GAIN=MAX, 20 Hz-20 kHz, CH1-8 MIC |
| Crosstalk @ 1 kHz | -68 dB |
| Input Connectors | CH 1-8: XLR and Phone CH 9/10-15/16: XLR. Phone and Pin |
| Channel EQ | CH 1-8: HIGH (10 k, Shelving), MID (mono: 250-5 k, st:
2.5 k, Peaking), LOW (100, Shelving) CH 9/10-15/16: HIGH (10 k, Shelving), MID (st: 2.5 k, Peaking), LOW (100, Shelving) |
| Phantom Voltage | 48 V |
| Digital Graphic Equalizer | 9 Band (63, 125, 250, 500, 1 k, 2 k, 4 k, 8 k, 16 kHz), Preset x 3, User preset x 3 |
| Digital Effects | SPX Digital Multi Effector (24 bit AD/DA, 32 bit Internal Processing): 16 Programs x 2 |
| Power Amp. Mode | L/R, AUX1/MONO, AUX1/2 |
| Foot Switch | Effect On/Off |
| Dimensions (W x D x H) | 444 x 493 x 155 mm (17-3/8" x 19-3/8" x 6-1/8") |
| Weight | 11 kg (24.2 lbs.) |
| Power Requirements/Consumption | 120 V 60 Hz, 500W 220-240 V 50 Hz, 500W |
*All level controls are nominal, when measured. Output impedance of signal generator: 150 Ω
INPUT CHARACTERISTICS
Input
Terminals |
PAD |
GAIN |
Actual Load Impedance |
For Use With Nominal |
Input level |
Connector |
||
|---|---|---|---|---|---|---|---|---|
Sensitivity *2 |
Position |
Max. Before Clip |
||||||
CH INPUT
A 1-8 |
0dB | -60 dB | 3 kΩ |
50-600 Ω Mics |
-80 dBu (0.078 mV) |
-60 dBu (0.775 mV) |
-40 dBu (7.75 mV) |
XLR-3-31 type *3 |
| -16 dB | -36 dBu (12.3 mV) |
-16 dBu (123 mV) |
+4 dBu (1.23 V) |
|||||
| 26dB | -34 dB | -54 dBu (1.55 mV) |
-34 dBu (15.5 mV) |
-14 dBu (155 mV) |
||||
| +10 dB | -10 dBu (245 mV) |
+10 dBu (2.45 V) |
+30 dBu (24.5 V) |
|||||
CH INPUT B 1-8 |
0dB | -60 dB | 10 kΩ |
600 Ω Lines |
-80 dBu (0.078 mV) |
-60 dBu (0.775 mV) |
-40 dBu (7.75 mV)) |
Phone Jack *4 |
| 26dB | -16 dB |
-36 dBu (12.3mV) |
-16 dBu (123mV) |
+4 dBu (1.23V) |
||||
| -34 dB |
-54 dBu (1.55 mV) |
-34 dBu (15.5 mV) |
-14 dBu (155mV) |
|||||
| +10 dB |
-10 dBu (245 mV) |
+10 dBu (2.45V) |
+30 dBu (24.5 V) |
|||||
| ST CH MIC INPUT 9/10-15/16 | — |
-60 dB | 3 kΩ |
50-600 Ω Mics |
-80 dBu (0.078 mV) |
-60 dBu (0.775 mV) |
-40 dBu (7.75 mV) |
XLR-3-31 type *3 |
| -16 dB | -36 dBu (12.3 mV) |
-16 dBu (123 mV) |
-10 dBu (245 mV) |
|||||
ST CH LINE INPUT 9/10-15/16 |
— |
-34 dB | 10 kΩ |
600 Ω Lines |
-54 dBu (1.55 mV) |
-34 dBu (15.5 mV) |
-14 dBu (155mV) |
Phone Jack *5 RCA Pin Jack*5 |
| +10 dB | -10 dBu (245 mV) |
+10 dBu (2.45 V) |
+30 dBu (24.5 V) |
|||||
CH INSERT IN (1-8) |
— |
— |
10 kΩ |
600 Ω Lines |
-20 dBu (77.5 mV) |
0 dBu (0.775 V) |
+20 dBu (7.7.5 V) |
Phone Jack *5 |
*1 0 dBu is referenced to 0.775 Vrms.
*2 Sensitivity is the lowest level that will produce an output of +4 dB (1.23 V), or the nominal output level when the unit is set to maximum level.
(All level controls are at maximum position.)
*3 XLR-3-31 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
*4 Phone Jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND)
*5 Phone Jacks are unbalanced.
*2 Sensitivity is the lowest level that will produce an output of +4 dB (1.23 V), or the nominal output level when the unit is set to maximum level.
(All level controls are at maximum position.)
*3 XLR-3-31 type connectors are balanced. (1=GND, 2=HOT, 3=COLD)
*4 Phone Jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND)
*5 Phone Jacks are unbalanced.
OUTPUT CHARACTERISTICS
Output Terminals |
Actual Source
Impedance |
For Use With
Nominal |
Output level |
Connector |
|
|---|---|---|---|---|---|
Nominal |
Max. before clip |
||||
| ST OUT [L, R] | 150 Ω | 600 Ω Lines | +4 dBu (1.23 V) | +20 dBu (7.75 V | Phone Jack *2 |
| ST SUB OUT [L, R] | 150 Ω | 600 Ω Lines | +4 dBu (1.23 V) | +20 dBu (7.75 V) | Phone Jack *2 |
| AUX SEND 1, 2 | 150 Ω | 600 Ω Lines | +4 dBu (1.23 V) | +20 dBu (7.75 V) | Phone Jack *2 |
| EFFECT SEND 1,2 | 150 Ω | 600 Ω Lines | +4 dBu (1.23 V) | +20 dBu (7.75 V | Phone Jack *2 |
| CH INSERT OUT 1-8 | 600 Ω | 10 kΩ Lines | 0 dBu (0.775 V) | +20 dBu (7.75 V | Phone Jack *2 |
| REC OUT [L, R] | 600 Ω | 10 kΩ Lines | -10 dBV (316 mV) | +10 dBV (3.16 V) | RCA Pin Jack |
| PHONES [L, R] | 100 Ω | 40 Ω Lines | 3mW | 75mW | Phone Jack (TRS) |
| SPEAKERS | 0.1 Ω | 4 Ω Speakers | 125W | 500W | SPEAKON Phone Jack *2 |
*1 0 dBu is referenced to 0.775 Vrms. 0 dBV is referenced to 1 Vrms.
*2 Phone Jacks are unbalanced.
*2 Phone Jacks are unbalanced.
