TF-RACK Digital Mixer

TF-RACK
Mixing Capacity Input Channels 40 (32 mono + 2 stereo + 2 return)
Aux Buses 20 (8 mono + 6 stereo)
Stereo Buses 1
Sub Buses 1
Input channel functions 8 DCA Groups
I/O Inputs 16 mic/line (XLR/TRS combo) + 1 stereo line (RCA pin)
Outputs 16 (8 XLR + 8 TRS phone)
Expansion slots 1 (for NY64-D)
On-board processors DSP 8 Effects + 10 GEQ
Sampling frequency rate Internal 48 kHz
Signal delay Less than 2.6 ms, INPUT to OMNI OUT, Fs=48 kHz
Fader Resolution = 10-bit, +10 dB to –138 dB, –∞ dB all faders
Total harmonic distortion Less than 0.05% 20 Hz–20 kHz @+4 dBu into 600 Ω, INPUT to OMNI OUT, Input Gain=Min. (Measured with a –18 dB/octave filter@80 kHz)
Frequency response +0.5, –1.5 dB 20 Hz–20 kHz, refer to +4 dBu output @1kHz, INPUT to OMNI OUT
Dynamic range 110 dB typ., DA Converter, 108 dB typ., INPUT to OMNI OUT, Input Gain=Min.
Hum & noise level Equivalent input noise –128 dBu typ., Input Gain=Max. (Measured with an A-Weight filter)
Residual output noise –85 dBu, ST master off (Measured with an A-Weight filter)
Crosstalk –100 dB (Measured with a –30 dB/octave filter@22 kHz), adjacent INPUT/OMNI OUT channels, Input Gain=Min.
Power requirements 100–240 V 50/60 Hz
Power consumption 85 W
Dimensions W 480 mm (18-7/8 in)
H 132 mm (5-1/4 in)
D 409 mm (16-1/8 in)
Net weight 9.2 kg (20.3lb)
Accessories Quick Guide, Power Cord NUENDO LIVE (DAW Software), Rubber stoppers(4)
Options Audio Interface Card (NY-64D), Foot Switch (FC5)
Others Operating temperature range: 0–40 °C, Storage temperature range: -20–60 °C
  • Recording/ Playback

    PC/Mac (USB2.0)Recording 34 tracks, Playback 34 tracks
    USB Storage DeviceRecording 2 tracks (USB hard drive/ SSD)*, Playback 2 tracks (USB hard drive/ SSD/ thumb drive)

    *Please note - USB thumb drives are not supported by TF for recording purposes. Please refer to this link for compatible hard drives.

    Analog input characteristics

    Input TerminalsGAINLoad
    Impedance
    For Use With
    Nominal
    Input LevelConnectorbalanced /
    Unbalanced
    Sensitivity*1 Nominal Max. before clip
    INPUT1-16+66dB7.5KΩ
    50-600Ω Mics
    or 600Ω Lines
    -82dBu (61.6μV)-62dBu (0.616mV)-42dBu (6.16mV)Combo Jack (XLR-3-31 type *2
    or TRS phone *3)
    Balanced
    -6dB -10dBu (245mV) +10dBu (2.45V)+30dBu (24.5V)
    ST IN10kΩ600Ω Lines-30dBV (31.6μV)-10dBV (316mV)+10dBV (3.16V)RCA Pin JackUnbalanced

    *1. Sensitivity is the lowest level that will produce an output of +4dBu (1.23V) or the nominal output level when the unit is set to maximum gain. (All faders and level controls are at maximum position.)
    *2. 1: GND, 2: HOT, 3: COLD
    *3. Tip: HOT, Ring: COLD, Sleeve: GND
    *4. In these specifications, 0dBu = 0.775Vrms.
    *5. +48V DC (phantom power) can be supplied to INPUT XLR type connectors via each individual software controlled switch.

    Analog output characteristics

    Output TerminalsSource
    Impedance
    For Use With
    Nominal
    Output LevelConnectorbalanced /
    Unbalanced
    Nominal Max. before clip
    OMNI OUT 1-875Ω600Ω Lines
    +4dBu (1.23 V)+24dBu (12.3 V)XLR-3-32 type *1Balanced
    OMNI OUT 9-16 TRS Phone Jack *6
    PHONES *5100Ω40Ω Phones3mW75mWStereo Phone Jack (TRS) *2Unbalanced

    *1. 1: GND, 2: HOT, 3: COLD
    *2. Tip: LEFT, Ring: RIGHT, Sleeve: GND
    *3. In these specifications, 0dBu = 0.775Vrms.
    *4. All output DA converters are 24bit, 128times oversampling.
    *5. The position of the level control is lowered by 16dB from the maximum.
    *6. Tip: HOT, Ring: COLD, Sleeve: GND

    Digital input/output specifications

    TerminalsFormatData lengthAudioConnector
    USB (TO HOST) USB 24bit 34ch input / 34ch output, PCM USB (B type)
    iPadUSBPlayback: MP3 or WAV file data / Record: WAV file data
    USB (A type)

     

    Control I/O specifications

    TerminalsFormatLevelConnector
    NETWORK IEEE802.3 10BASE-T/100Base-TX RJ-45
    FOOT SWTS Phone