EMX (Box type)
General Specifications
| Maximum Output Power @ 0.5 % THD at 1 kHz | 300 W/4 Ω; 190 W/8 Ω | Frequency Response | -3, 0, 1 dB 20 Hz-20 kHz, ref to the nominal output level @ 1 kHz | Total Harmonic Distortion | Less than 0.5 % (THD+N) +14 dB @ 20 Hz, 1 kHz, 20 kHz, GAIN control: all nominal | Hum & Noise | Equivalent Input Noise, -115 dBu, Rs = 150 Ω CH 1-4 MIC/LINE: MIC | Crosstalk | -65 dB @ 1 kHz | Input Connectors | CH 1-4: XLR and Phone; CH 5/6, 7/8: XLR and Phone; CH 9/10, 11/12: XLR and Pin | CH EQ | HIGH, MID, LOW | Phantom Power | 15 V | Graphic Equalizer | 7 Band (125, 250, 500, 1 k, 2 k, 4 k, 8 kHz): Main (Stereo) and Monitor | Digital Effects | SPX Digital Multi Effector (24 bit AD/DA, 32 bit Internal Processing): 16 Programs | Power Amp Mode | Main L/R, Main (L+R)/Monitor | Foot Switch | On/Off | Dimensions (W x D x H) | 442 x 274 x 286 mm (17-3/8" x 10-3/4" x 11-1/4") | Weight | 10 kg (22 lbs.) | Power Requirements | 120 V 60 Hz | Power Consumption | 400 W |
|---|---|---|
INPUT CHARACTERISTICS
| Input Terminals | MIC/LINE | Actual Load Impedance | For Use With Nominal | Input level | |||
|---|---|---|---|---|---|---|---|
| Sensitivity *2 | Position | Max. before clip | |||||
| CH INPUT 1-4 | XLR *3 |
MIC | 2 kΩ | 50-600 Ω Mics | -60 dBu (0.69 mV) |
-35 dBu (13.8 mV) |
-15 dBu (138 mV) |
| LINE | -30 dBu (21.8 mV) |
-5 dBu (436 mV) |
+15 dBu (4.36 V) |
||||
| Phone *4 |
MIC | 6 KΩ | 600 Ω | -50 dBu (2.18 mV) |
-25 dBu (43.6 mV) |
-5 dBu (436 mV) |
|
| LINE | -20 dBu (69.0 mV) |
+5 dBu (1.38 V) |
+25 dBu (13.8 V) |
||||
| CH INPUT 5/6, 7/8 | XLR *3 |
- | 2 kΩ | 50-600 Ω Mics | -60 dBu (0.69 mV) |
-35 dBu (13.8 mV) |
-15 dBu (138 mV) |
| Phone *5 |
- | 10 KΩ | 600 Ω Lines | -20 dBu (69.0 mV) |
+5 dBu (1.38 V) |
+25 dBu (13.8 V) |
|
| CH INPUT 9/10, 11/12 | XLR *3 |
- | 2 kΩ | 50-600 Ω Mics | -60 dBu (0.69 mV) |
-35 dBu (13.8 mV) |
-15 dBu (138 mV) |
| RCA Pin |
- | 10 KΩ | 600 Ω Lines | -20 dBu (69.0 mV) |
+5 dBu (1.38 V) |
+25 dBu (13.8 V) |
|
*1 0 dBu is referenced to 0.775
Vrms.
*2 Sensitivity is the lowest level
that will produce an output of
+4 dB (1.23 V), or the nominal
output level when the unit is set
to maximum level. (All level controls
are at
maximum position.)
*3 XLR-3-31 type connectors are
balanced. (1=GND, 2=HOT, 3=COLD)
*4 Phone Jacks are balanced. (Tip=HOT,
Ring=COLD, Sleeve=GND)
*5 Phone Jacks are unbalanced.
OUTPUT CHARACTERISTICS
| Output Terminals | Actual Source Impedance | For Use With Nominal | Output level | Connector | ||
|---|---|---|---|---|---|---|
| Nominal | Max. before clip | |||||
| SPEAKER OUT | 0.1 Ω | 4 Ω Speakers | EMX512SC | 125 W | 500 W | [A1, B1] SPEAKON |
| [A1, A2, B1, B2] | EMX312SC | 75 W | 300 W | [A2, B2] Phone Jack *2 | ||
| EMX212S | 50 W | 200 W | ||||
| MAIN OUT [L, R] | 600 Ω | 10 kΩ Lines | - | +4 dBu (1.23 V) | +20 dBu (7.75 V) | Phone Jack *2 |
| EFFECT OUT | 600 Ω | 10 kΩ Lines | - | +4 dBu (1.23 V) | +20 dBu (7.75 V) | Phone Jack *2 |
| MONITOR OUT | 600 Ω | 10 kΩ Lines | - | +4 dBu (1.23 V) | +20 dBu (7.75 V) | Phone Jack *2 |
| REC OUT [L, R] | 600 Ω | 10 kΩ Lines | - | -10 dBV (316 mV) | +10 dBV (3.16 V) | RCA Pin Jack |
*1 0 dBu is referenced to 0.775 Vrms. 0 dBV is referenced to 1 Vrms.
*2 Phone Jacks are unbalanced.
